WD8BXS
alter Hase
 Offline
Posts: 286
|
 |
Version 6.3 issue
« on: 02. December 2019, 14:31:41 »
|
|
Just finishing a ver 6.3
I have very low output on 20 meters.
10 mhz will give full output, but you have to drive it harder than usual.
I have triple checked the LPF and bandpass filter, no success.
Does anyone have any ideas where to look next?
Thanks,
Chuck
|
| « Last Edit: 02. December 2019, 14:32:09 by WD8BXS » |
 Logged
|
Thanks,
De WD8BXS vy 73
|
|
|
WD8BXS
alter Hase
Offline
Posts: 286
|
|
Re:Version 6.3 issue
« Reply #1 on: 02. December 2019, 15:54:13 »
|
|
Very nice answer, I will change them out and see.
Thanks,
Chuck
|
|
Logged
|
Thanks,
De WD8BXS vy 73
|
|
|
SP3OSJ
Guest
|
|
Re:Version 6.3 issue
« Reply #2 on: 02. December 2019, 16:03:15 »
|
|
Hi
You used the wrong integrated circuits.
You have probably installed CBT3253 and you should use CBT3253C
Good luck!
Artur
|
| « Last Edit: 02. December 2019, 16:03:36 by SP3OSJ » |
Logged
|
|
|
|
WD8BXS
alter Hase
Offline
Posts: 286
|
|
Re:Version 6.3 issue
« Reply #3 on: 02. December 2019, 22:34:25 »
|
|
Replaced both CBT3253C chips....No difference.
Chuck
|
|
Logged
|
Thanks,
De WD8BXS vy 73
|
|
|
OE3HKC
alter Hase
Offline
Posts: 348
Ich liebe dieses Forum und meinen MiniTRX !!
|
|
Re:Version 6.3 issue
« Reply #4 on: 03. December 2019, 07:00:43 »
|
|
how is sensitivity of receiver part on 20m?
if ok, perhaps menu tx settings (20m) are wrong..
73
|
|
Logged
|
wer immer strebend sich bemüht, dem wird es auch gelingen !!
|
|
|
SP9BSL
positron
alter Hase
Offline
Posts: 443
|
|
Re:Version 6.3 issue
« Reply #5 on: 03. December 2019, 09:42:25 »
|
|
Hi,
I would use oscilloscope, 14 MHz is not so high frequency. Just follow the path of the signal with oscilloscope probe using TUNE.
|
|
Logged
|
73 Slawek
|
|
|
Author
