Diskussions- und Newsboard des DARC-Ortsverbandes I40 
allgemeine Kategorie => UHSDR Firmware => Message started by: EB3AM on 01. November 2020, 23:55:13
Title: Reset filters and DSP
Post by: EB3AM on 01. November 2020, 23:55:13
Hello, I very novice with UHSDR
I looking to adjust the NR / ANR to make better quality but now I have a hi frequency sound in DSP modes...
I search into the menus, and here for a simple solution to restore defaults values into this parameters.
I try F1-F3-F5... but... :'( nothing works!!!
I can restore all, but hi freq sound again!

Is possible to put in default only the DSP /nr/anr settings and not touch bias,iq,etc...??
Title: Re:Reset filters and DSP
Post by: DF8OE on 02. November 2020, 05:45:32
You can press DEFLT (default= on every single adjustment point.

vy 73
Andreas
Title: Re:Reset filters and DSP
Post by: EB3AM on 02. November 2020, 12:32:57
Thanks, I see ::)

Sorry!


Diskussions- und Newsboard des DARC-Ortsverbandes I40 | Powered by YaBB SE
© 2001-2003, YaBB SE Dev Team. All Rights Reserved.