Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste ÜberarbeitungBeide Seiten der Revision | ||
ovi40build:uiboardbuild [25.01.2018 16:01] – df9ts | ovi40build:uiboardbuild [25.01.2018 20:39] – df9ts | ||
---|---|---|---|
Zeile 5: | Zeile 5: | ||
==== OVI40 UI V1.7 Unterlagen ==== | ==== OVI40 UI V1.7 Unterlagen ==== | ||
- | **UI V1.7 documents sind nur zur Information**. Bitte benutzt | + | **UI V1.7 documents sind nur zur Information**. Bitte benutzt bevorzugt die V1.8 Unterlagen für den Zusammenbau einer V1.8 UI. |
* {{: | * {{: | ||
Zeile 24: | Zeile 24: | ||
|< 60% 33% 33% 33% >| | |< 60% 33% 33% 33% >| | ||
+ | |||
|[{{: | |[{{: | ||
Zeile 31: | Zeile 32: | ||
|< 95% 50% 50% >| | |< 95% 50% 50% >| | ||
+ | |||
| [{{: | | [{{: | ||
Zeile 37: | Zeile 39: | ||
Wichtig: zuerst die V1.8 [[: | Wichtig: zuerst die V1.8 [[: | ||
- | === IC Device Markings === | + | === Code Nummern auf den ICs ("Device Markings" |
- | The smaller ICs can be identified by device mark. The following device marks are used: | + | Da auf den kleinsten Halbleitern der Platz für einen kompletten Bauteilenamen fehlt, werden einige Bauteile nur mit einem Code bedruckt. Bedeutung der Codes: |
|< 45% 25% 25% 25% 25% >| | |< 45% 25% 25% 25% 25% >| | ||
Zeile 49: | Zeile 51: | ||
|BAS85 | |BAS85 | ||
- | === MCU STM32 "Pin 1" | + | === MCU STM32 "Pin 1" |
- | Please understand the correct orientation of STM32 MCU Pin 1. There are two markings on the IC. Please not the text printed on MCU to find the correct | + | Bitte die korrekte "Pin 1" Markierung der STM32 MCU beachten. Diese MCU hat 2 MArkierungen, |
- | [{{: | + | [{{: |
- | < | + | === STM32F76X_ZIT vs. STM32H743ZIT6 === |
- | | + | |
- | </ | + | |
- | The kit is shipped with STM32F76X_ZIT (" | + | Der Bausatz wird mit der MCU STM32F76X_ZIT (" |
- | Comparison of MCUs: | + | Vergleich derMCUs: |
|< 90% 25% 25% 25% 25% >| | |< 90% 25% 25% 25% 25% >| | ||
Zeile 69: | Zeile 69: | ||
|Flash[kB] | |Flash[kB] | ||
|RAM [kB] |192 |512 |1024 | | |RAM [kB] |192 |512 |1024 | | ||
- | |Clock[MHz] |168 |216 |400 | | + | |Takt[MHz] |168 |216 |400 | |
|FPU |single | |FPU |single | ||
|Pins |100 |144 |144 | | |Pins |100 |144 |144 | | ||
|DMIPS | |DMIPS | ||
- | === EEPROM IC7 orientation | + | === EEPROM IC7 Orientierung |
- | + | ||
- | [{{: | + | |
- | + | ||
- | This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http:// | + | |
- | + | ||
- | === Prevent short cut with back up battery holder === | + | |
- | + | ||
- | One of the connection pins of the battery holder might touch ground connection of a rotary encoder. Make sure to cut this pin flush with PCB surface **before soldering** | + | |
- | + | ||
- | [{{: | + | |
- | === Polarised capacitors === | + | [{{: |
- | Please observe mounting orientation of tantal and electrolytic capacitors. Markings on the capacitors are explained | + | Auf dem Photo ist der "Pin 1" Punkt klar zu sehen. Die IC Seite mit den Pins 1..4 ist ausserdem leicht abgeschrägt. Siehe auch [[http://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-8828-SEEPROM-AT24CM02-Datasheet.pdf|hier]] |
- | === Mounting locations of switches S7 and S8 === | + | === Kurzschluß am Batterie-Halter vermeiden |
- | Two different mounting locations are provided on the UI PCB for S7 and S8: | + | Das OVI40 UI PCB ist sehr kompakt und an bestimmten Stellen geht es deshalb eng zu. Einer der Pins des Batterie-Halters **muß** |
- | | + | * "OVI40 style": |
- | | + | |
- | "In line" | + | "In line" |
- | ==== Modifications | + | ==== Modifikationen |
- | === Temporary Modification: Resistor in parallel | + | === Provisorische Modifikation: Widerstand |
- | Symptom: | + | Symptom: |
- | === Change brightness of LEDs === | + | === Helligkeit der LEDs ändern |
Helle LEDS: Mit den Bausatz-Vorwiderständen leuchten die LEDs sehr hell. DF9EH hat die Werte reduziert: | Helle LEDS: Mit den Bausatz-Vorwiderständen leuchten die LEDs sehr hell. DF9EH hat die Werte reduziert: |